【KURO-SHEEVA】起動デバイスとu-bootの設定

◎ uImage：NANDフラッシュ､root：NANDフラッシュ

setenv bootargs 'console=ttyS0,115200 mtdparts=nand_mtd:0x400000@0x100000(uImage),0x1fb00000@0x500000(rootfs) rw root=/dev/mtdblock1 rw ip=10.4.50.4:10.4.50.5:10.4.50.5:255.255.255.0:DB88FXX81:eth0:none'
setenv bootcmd 'nand read.e 0x800000 0x100000 0x400000; bootm 0x800000'
setenv mainlineLinux no
saveenv

reset

◎ uImage：NANDフラッシュ､root：eSATA

setenv bootargs console=ttyS0,115200 mtdparts=nand_mtd:0x400000@0x100000(uImage),0x1fb00000@0x500000(rootfs) rw root=/dev/sda2 rw rootdelay=10 ip=10.4.50.4:10.4.50.5:10.4.50.5:255.255.255.0:DB88FXX81:eth0:none
setenv bootcmd 'nand read.e 0x800000 0x100000 0x400000; bootm 0x800000'
setenv mainlineLinux no
saveenv
reset

◎ uImage：SDカード､root：SDカード

setenv bootargs 'console=ttyS0,115200 mtdparts=orion_nand:0x400000@0x100000(uImage),0x1fb00000@0x500000(rootfs)rw root=/dev/mmcblk0p3 rootfstype=ext2 rootdelay=3'
setenv bootcmd 'mmcinit; ext2load mmc 0:1 0x800000 /uImage; bootm 0x800000'
setenv mainlineLinux yes
setenv arcNumber 2097

saveenv 

reset